Installation and commissioning of gypsum powder machine

1. The equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts.

2. During installation, attention should be paid to the vertical position of the main body and the horizontal.

3. After installation, check whether the bolts in each part are loose and whether the main engine compartment door is fastened. If so, please tighten it.

4. Configure the power cord and control switch according to the power of the device.

5. After the inspection is completed, conduct a no-load test run, and production can proceed once the test run is normal.

The bearings of the gypsum powder machine bear all the load of the machine, so good lubrication has a great relationship with the bearing life. It directly affects the service life and operating rate of the machine. Therefore, it is required that the injected lubricating oil must be clean and well sealed. The main oil injection points of this machine include (1) rotating bearings, (2) rolling bearings, (3) all gears, (4) movable bearings, and sliding surfaces